Each scheduled trip includes:

• Inspection of cooling system fan, fan blades, remote cooling fan motor.
• Inspection of all cooling system hoses, and adjustment of hose clamps if necessary.
• Inspection of engine belts and belt tensions, with adjustment if necessary.
• Inspect engine block heater for proper operation, temperature and flow.
• Inspect and clean generator controller and area, if required.
• Inspect and clean gauges for proper operation, and adjust if needed.
• Check shut down functions, including emergency stop for proper operation.
• Inspect Automatic Transfer Switch for proper operation, with or without load.
• Check time delays in Automatic Transfer Switch for settings.
• Check and adjust exercise clock timer in Automatic Transfer Switch.
• Verify proper operation of Remote Annunciator panel.
• Check all bulbs in controller for proper operation.
• Inspect and test both engine battery charging alternator, and the system battery charger, and adjust if necessary.
• Start and run generator set to verify proper operation of unit.
• Check and adjust all gauges.
• Check anti-freeze / coolant level, and adjust if necessary.
• Inspect generator for oil, fuel and coolant leaks.
• Inspect exhaust system and silencer for leaks, cracks and deterioration.
• Drain moisture for exhaust piping (if equipped).
• Check batteries for water level, level of charge and corrosion on terminals.
• Check fuel system, including day tank or transfer tank (if equipped).